18Use
Press simultaneously the buttons 2 and 3 for some seconds: the EXTRA RINSE pilot light comes on in the programme progress display. This function stays per- manently on. To remove it press the same buttons again until the EXTRA RINSE light goes off.
Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the button 8.
Changing a running programme is possible only by resetting it. Turn the programme selector dial to O/OFF and then to the new programme position. Start the new programme by depressing the button 8 again. The washing water in the tub will be not emptied out.
Interrupting a programme
Depress the button 8 to interrupt a programme which is running, the corresponding light starts blinking. Depress the button again to restart the programme.
Cancelling a programme
Turn the selector dial to O/OFF to cancel a programme which is running. Now you can select a new programme.
Opening the door after the programme has started
First set the machine to PAUSE by pressing the button 8.
If the DOOR light goes off, the door can be opened.
If the DOOR light remains lit, this means that the machine is already heating, that the water level is above the bottom edge of the door. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to O/OFF. After about some minutes the door can be opened (pay attention to the water level and temperature!).