AEG 135 EL Electrical connection, Permanent connection, Directly into a, Not more than 90 cm End

Page 42

Installation

Directly into a

drain pipe at a height of not less than 60 cm and

not more than 90 cm.

The end of the

drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase, 50 Hz supply.

Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

This operation has only to be performed by a qualified electrician.

85

Image 42
Contents Lavamat 135 EL Dear customer Contents Page Positioning, connection, starting up Safety instructionsGeneral notes Follow the instructions for positioning and connectionChild safety Proper useDiscarding Packaging materialsMachine Tips for environmental protection Main features of your washing machine Description of the appliance Front viewON/OFF button Açma Kapama Control panelMains on light Buttons and corresponding functionsDelay Start button Geciktirme TU‚U DisplayDisplay shows the following information Extra Rinse button EK Durulama Quick Wash button Kisa YikamaPrewash button ÖN Yikama Anticrease button stop with water in drumStart START/PAUSE button Start ARA VermeSpin Speed button Sikma PauseSymbols on the programme selector Programme phase indicatorCancelling a programme Programme selectorOpening the door after the programme has started Detergent and additive dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryColoureds Types of fabric and care labelsWhites Coloureds 40Delicates 40 Woollens and particularly delicate itemsDetergents and additives Load the laundry How to washSwitching the machine on Add detergent and additiveSpin Speed Sikma button the corre Sponding light comes on Selection of the desired wash programmeSelection of the spin speed Corresponding light comes onSelection of the Delay Start option Geciktirme TU‚U Starting the programmeAt the end of the programme Programme chart Wash programmesWash Temp Fabrics Additional Max Consumption Special programmes TypeMax Consumption Laundry After each wash Cleaning and maintenancePeriodical cleaning Bodywork Detergent dispenser drawerDrain filter Water inlet filterFrost precautions Emergency emptying outTroubleshooting Problem Possible cause SolutionSomething not working? Problem Possible cause SolutionFeet have not been Problem Possible cause Solution Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryTechnical data This appliance complies with the following EC directivesService Instructions for installation and electrical connection Safety instructionsDimensions of the appliance Rear viewInstallation UnpackingPositioning LevellingBefore placing it on small tiles, apply a rubber coating Directly into a Electrical connectionPermanent connection Not more than 90 cm EndWater inlet Water drainageEnd of the drain hose can be positioned in three ways