INSTALLATION
Installing the ground pin
•The ground pin in the plug should be connected to the proper point of the socket for grounding.
Installing the drainage hose
Moving the hook
•When inserting the drainage hose into a wash pan or onto a drain pipe, the hook may be moved to facilitate the installation.
•When hooking the hose hook into the slot provided on the body of your washing machine,
move the hook back to its initial |
| Hook | ||
position. |
|
| ||
|
| Drainage hose | ||
• Insert the drainage hose |
|
| Hose band | |
in as far as it will go, then |
|
|
| |
use the accessory hose |
|
|
| |
band to secure it tightly. |
|
|
| |
• Secure the hose tightly. |
|
|
| |
An improperly secured |
| Drain pipe Drainage hose | ||
hose may cause leakage. |
|
|
| |
• When attaching the drainage | Gap |
| ||
hose to a wash pan, etc., | 3 cm or | |||
|
| |||
either leave a gap between |
|
| greater | |
the end of the hose and the |
|
|
| |
adjacent surface, or cut the |
| |
hose diagonally to ensure | Cut diagonally | |
proper drainage. | ||
Drainage hole | ||
| ||
Allowing the flat end of the |
| |
hose to come in contact |
| |
with the flat surface of the |
| |
washing machine will |
| |
impair drainage. |
|
Drainage hose extension
•Pay close attention to the height of the drainage hose and articles over which it passes. If the drainage hose is too high, proper drainage may not be obtained.
•The length of the
drainage hose may be | 3 m or less | |
extended to as much | ||
| ||
as 3 m if kept the same |
| |
level. | Drainage hose cap | |
|
Caution:
•If the level of the threshold and the drainage hose is high, the washing machine may not be drained.
15 cm or less
•Be careful not to rub the drainage hose. Do not insert the drainage hose under the washing machine. They may be damaged the drainage hose.
Concrete block
Drainage hose
Moving the drainage hose The drainage hose can be installed on either the right or left side.
The connector port for the drainage hose is found on the right side of the washing machine, but it can be changed without disconnecting the internal hose from the drainage valve.
1 Remove the back cover, then grip the stopper securing the internal hose with your fingers and pull it up.
2 Turn the nut for the drainage hose connector port counterclockwise.
3 Pull the internal hose from inside the washing machine to detach.
4 Remove the hose hole cap on the
Stopper
Nut
Tap
Hose hole cap
Upper and lower notches in the hose hole
5 Turn the stopper 180°C without removing from hose. Insert the stopper into the securing hole on the left side of the outer shell and press down to secure the internal hose.
Drainage valve
Stopper
6 Attach the back cover, and fit the hose hole cap over the hose hole on the
place, then from outside put the nut in place and turn clockwise to secure.
Outer shell
Nut
7 After moving the drainage hose, be sure to testoperate the washing machine, ensuring that there are no water leaks or unusual noises.
12
6348100701 | 12 | 22/10/08, 11:19 |