Invacare Adjustable ASBA Seat Removing/Installing the Power Elevating Legrest Actuator

		SECTION 7—POWER ELEVATING LEGRESTS
Rear Arm Socket	T-nut	NOTE: T‐nuts shown
Rear Harness Wire Bracket		exploded away from
		seat frame for clarity.
Washer
Hex Screw		Seat Frame
2-pin Anderson
Connector (To TRECM		T-Nut
or DLIAM)

Tie-Wrap	Locknuts
	Front Harness Wire Bracket
Harness	Washer
Power Elevating Legrest Connector	Hex Screw
	Cap Screws
(To Legrest)

DETAIL “A” - TIE-WRAP

Rear Harness

Wire Bracket

Tie-wrap

Harness

DETAIL “B”

Jumper

Cable

Power

Legrest

Connector

FIGURE 7.9 Removing/Installing the Power Elevating Legrest Harness

Removing/Installing the Power Elevating Legrest Actuator

NOTE: For this procedure, refer to FIGURE 7.10 on page 42.

Removing

1.Remove the power elevating legrest from the wheelchair. Refer to Installing/ Removing the Power Elevating Legrests on page 34.

2.Disconnect the actuator connector (not shown) from the TRECM or DLIAM connector (not shown).

3.Remove the long shoulder screw, flat washer, washer and locknut securing the top of the power elevating legrest actuator to the power legrest bracket.

Part No 1143238 41 Adjustable ASBA Seat