SECTION
Installing the Mounting Hardware onto the Contoura Back
1.Secure two of the front mounting brackets to the mounting holes in the Contoura back using two socket screws, four washers and two locknuts. Torque to 75 in‐lbs ± 20%.
2.Loosely attach the remaining two front mounting brackets to the slots in the Contoura back using two socket screws, four washers and two locknuts.
NOTE: The two socket screws and locknuts will be tightened when the Contoura back is installed onto the back canes.
3. Install the Contoura back. Refer to Installing the Contoura Back on page 48.
Contoura Back
Back Cane
Washer
Locknuts
Socket
Screw*
Rear
Mounting
Bracket
Mounting
Screw
Socket
Screw*
Lower Front
Mounting Bracket
Back Cane
Upper Front
Mounting Bracket
Mounting Socket
Screw Screws*
Washer
Lower Front
Mounting Bracket
Washer
Socket
Screws**
Washer
*NOTE: Remove these socket screws when removing the back from the back canes.
**NOTE: Remove these socket screws when removing the hardware from the back.
FIGURE 9.1 Removing/Installing the Contoura Back
Part No 1143238 | 49 | Adjustable ASBA Seat |
