SECTION
SECTION 7—POWER ELEVATING LEGRESTS
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustments or service, ALWAYS turn the wheelchair power off, otherwise injury or damage may result.
Installing/Removing the Power Elevating Legrests
WARNING
To prevent personal injury, ALWAYS verify proper positioning of legs and feet prior to use. Individual user weight may impact the rate of travel for each legrest assembly. If simultaneous operation is desired, select a speed which allows for the most uniform travel.
DO NOT insert fingers between legrest components, otherwise personal injury may occur.
CAUTION
NEVER allow items to become trapped between the legrest assemblies, otherwise damage to the power legrests may occur.
Ensure that all parts of both power legrests are clear of any obstructions before raising and lowering. Otherwise damage to the power legrests may occur.
NOTE: For this procedure, refer to FIGURE 7.1 on page 35.
Installing the Power Elevating Legrests
1.Turn power legrest to side (open footplate is perpendicular to wheelchair) and align the mounting pin on the legrest with mounting hole in the hanger assembly (Detail “A”).
2.Insert the mounting pin of power legrest into the mounting hole of the hanger assembly (Detail “A”).
NOTE: Make sure the legrest sits flush on the hanger assembly.
3.Rotate the power legs toward the inside of the wheelchair until it locks in place. NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4.Repeat STEPS 1‐3 for the opposite legrest.
5.Connect power legrest connector to the harness (Detail “B”).
Adjustable ASBA Seat | 34 | Part No 1143238 |
