SECTION
70° Taper
NOTE: For this procedure, refer to FIGURE 6.2
1.Turn the footrest to the side (open footplate is perpendicular to wheelchair).
2.Insert footrest mounting pin into mounting tube.
|
| Footrest |
|
|
| Mounting Pin |
|
|
|
| Footrest |
|
|
| Release |
Mounting Tube |
| Lever | |
Footplate |
|
| |
3. Push the footrest towards the inside of | FIGURE 6.2 Installing/Removing Footrests - |
the wheelchair until it locks into place. | 70° Taper |
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4.Repeat STEPS 1‐ 3 for the other footrest assembly.
5.To remove the footrest, push the footrest release lever inward, rotate footrest outward.
6.Adjust footrest height if desired. Refer to Adjusting the Footrest Height on page 25.
Adjusting the Footrest Height
WARNING
Minimum ground clearance for the footrest is three inches - otherwise personal injury or damage may result.
PH904A and PHAL4A Front Riggings
NOTE: For this procedure, refer to
FIGURE 6.3.
1.Loosen, but DO NOT remove, the lug bolt and locknut that secure the lower footrest to the footrest support.
2.Reposition the lower footrest to the desired height.
3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.
4.Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest if necessary.
NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.
Footrest
SupportLocknut
Lower Footrest
Lug Bolt
FIGURE 6.3 Adjusting the Footrest Height
Part No 1143238 | 25 | Adjustable ASBA Seat |
