SECTION 7—POWER ELEVATING LEGRESTS

6.If necessary, adjust powered legs. Refer to Adjusting the Power Elevating Legrests below.

Removing the Power Elevating Legrests

1.Disconnect power legrests from the harness.

2.Push powered legrest release handle toward the opposite side of the wheelchair and swing legrest to the outside of the wheelchair.

3.Lift powered legrest and remove from wheelchair.

4.Repeat STEPS 1‐3 for opposite power legrest.

 

DETAIL “A”

Mounting

Calf Pad

Mounting Pin

Hole

 

Footplate

Legrest Release

Handle

DETAIL “B”

Jumper

Cable

Power

Legrest

Connector

FIGURE 7.1 Installing/Removing the Power Elevating Legrests

Adjusting the Power Elevating Legrests

Adjusting the Footplate

WARNING

DO NOT remove heel loops without providing some other adequate means of support. Otherwise personal injury may occur.

Adjusting the Footplate Height

NOTE: For this procedure, refer to FIGURE 7.2 on page 36.

NOTE: The following procedure should be performed with the user in the wheelchair.

NOTE: T‐nuts ride in the channels of the exterior/interior rails of the power legrests. Refer to FIGURE 7.2.

1.Loosen, but DO NOT remove, the two interior button screws that secure the footplate assembly to the T‐nuts.

Part No 1143238

35

Adjustable ASBA Seat

Page 35
Image 35
Invacare Adjustable ASBA Seat service manual Adjusting the Power Elevating Legrests, Removing the Power Elevating Legrests