SECTION 6—FRONT RIGGINGS

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 6.14.

Installing

1.Turn legrest to side (open footplate is perpendicular to wheelchair).

2.Install the legrest hinge plates onto the hinge pins on the wheelchair frame.

3.Rotate legrest toward the inside of the wheelchair until it locks in place. NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1‐3 for the opposite legrest.

5.After the user is seated in wheelchair, adjust footplate to correct height by loosening nut and sliding the lower footrest assembly up or down until desired height is achieved.

Calfpad

Hinge Pins

Legrest

Hinge Plates

Removing

1.Push the legrest release handle toward the inside of the wheelchair (facing the front of the wheelchair).

2.Swing the legrest to the outside of the wheelchair.

3.Lift up on the legrest and remove from the wheelchair.

4.Repeat STEPS 1‐2 for opposite side of wheelchair.

Legrest Release Handle

Bolt/Nut

FIGURE 6.14 Installing/Removing Elevating

Legrests

Adjustable ASBA Seat

32

Part No 1143238

Page 32
Image 32
Invacare Adjustable ASBA Seat service manual Installing/Removing Elevating Legrests