SECTION
7.Slide both front arm sockets (with T‐nuts) out of the slots in the side rails.
8.Pull both side rails off the crossbars.
Installing Side Rails
1. Install new side rails onto crossbars.
NOTE: Ensure long end of side rail is towards the front of the wheelchair.
2.Secure the side rails to the crossbars with the hex screws, washer and lanyard. Torque to 75 in‐lbs ± 20%.
3.Slide cane brackets (with T‐nuts and back assembly) into the slots in the side rails.
4.Slide front arm sockets (with T‐nuts) into the slots in the side rails.
5.Use a rubber mallet to tap the two roll pins into the side rails.
6.Adjust the seat depth. Refer to Adjusting the Seat Depth on page 65.
7.Tighten the four hex screws to secure the cane brackets to the side rails. Torque to 13 ft‐lbs ± 20%.
8.Install the armrests.
NOTE: It may be necessary to slide the front arm sockets to the proper position to install the armrests.
9.Tighten the four hex screws to secure the front arm sockets to the side rails. Torque to 13 ft‐lbs ± 20%.
Side View
Back
Cane
Side Rail
Crossbar
Washer
Roll
Pin
Hex Screws
Cane Bracket |
| Front Arm | ||||||||||||
|
|
|
|
|
|
|
|
| Socket | |||||
|
|
|
| Slot |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Hex Screws
FIGURE 11.4 Removing/Installing Side Rails
Part No 1143238 | 67 | Adjustable ASBA Seat |
