John Lewis JLWD 1610 Start the programme, How to change an option or a programme during its cycle

Page 14

programme will appear again. The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours.

You can cancel the delay time at any moment, before you press the «Start/ Pause» button.

Selecting the delayed start

You must select this option after you have set the programme and before you press the «Start/Pause» button.

•Select the programme and the required options.

•Select the delay start.

•Press button 8: the machine starts its hourly count down. The programme will start after the selected delay has expired.

Opening the door throughout the delay time

If you wish to add laundry in the machine during the delay time

•Press button 8 to put the machine in pause.

•Add the laundry, close the door

•Press 8 button again.

Cancelling the delayed start

•Press button 8.

•Press «Delay start» button once until the symbol «0’» is displayed.

•Press button 8 again.

The Delay Start cannot be selected with the draining programme.

Start the programme

To start the selected programme, press the button 8 ; the green pilot light stops flashing. If you have selected a delay time, the countdown will begin and will be shown on the display.

To interrupt a programme which is running, press button 8: the green pilot light starts to flash. To restart the programme from the

point at which it was interrupted, press the button 8 again. If an incorrect option is selected, the red pilot light of button 8 flashes 3 times and the message Err is displayed for a few seconds.

Important!

You must set the washing machine to Pause before you make any change in the programme in progress.

How to change an option or a programme during its cycle

It is possible to change some options before the programme carries them out. Before you make any change, you must pause the washing machine by pressing the button 8. Changing a running programme is possible only by resetting it.

Turn the programme selector dial to «Off» and then to the new programme position. Start the new programme by pressing the button 8. The washing water in the tub will not empty out

How to interrupt a programme

Press the button 8 to interrupt a programme which is running, the corresponding green pilot light starts blinking.

Press the same button again to restart the programme.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Jlwd Spin washer-dryer Safety information General safetyInstallation UseChild safety Keep all detergents in a safe place out of children’s reachContents Use Drying Product description Control panel Detergent dispenser drawerAutomatic dry Programme DialSpin Time dryExtra Rinse Door lock light Delay StartDisplay Start PausePersonalisation Acoustic signalsFirst use Load the laundry Daily useChild lock Measure out the detergentSelect the spin speed or Rinse hold option Select the delay startSelect the required programme Select the desired optionsStart the programme How to change an option or a programme during its cycleHow to interrupt a programme How to open the door during the cycle of a programme End of programmeUse Drying Drying onlyNON-STOP programme Washing and Timed Drying Use Washing & DryingNON-STOP programme Washing and Automatic Drying Before loading the laundry Helpful hints and tipsSorting out the laundry Removing stainsDegrees of water hardness Detergents and additivesQuantity of detergent to be used Laundry not suitable for drying Drying HintsPreparing the drying cycle Garment labelsEconomy Washing programmesAdditional drying White and fast coloured cotton heavily orDelicates SyntheticsSynthetics Easy Iron Rinses DrainOff Drying ProgrammesMinute wash Automatic Programmes Timed ProgrammesProgramme Energy Water Technical dataConsumption values Duration MinutesCare and cleaning Door seal Cleaning the drawer recessWashing drum Cleaning the pump Cleaning the water inlet filters Frost precautions Emergency emptying outInstallation UnpackingPositioning and levelling PlumbingWater inlet Water-stop deviceOnto a sink outlet spigot Water drainageInto a drainage standpipe Special conditions Interest of the environmentElectrical connection Appliance is supplied with a 13 amp plug fitted Permanent connectionWashing machine Problem Possible cause/SolutionWhat to do if… Does not startEmpty and/or does not Machine does not fillMachine does not SpinDoor will not open Unsatisfactory washingResults Machine vibrates0844 871 Repairs After Sales ServiceRepairs After Sales Service Packaging materials Environment concernsSpare parts Ecological hints132939140-A-022011
Top Page Image Contents