John Lewis JLWD 1610 How to open the door during the cycle of a programme, End of programme

Page 15

How to open the door during the cycle of a programme

You can open the door, after having set the washing machine to Pause, provided the following conditions exist:

The washing machine is not in the heating phase

The level of the water is not high;

If these requirements are met, when you pause the washing machine, the «Door lock» light goes off and the door can be opened.

Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by turning the selector dial to Off. After a few minutes, you can open the door.

Pay attention to the level and temperature of the water in the washing machine! When you close the door to restart the programme turn the dial to the previous programme and repeat the options previously selected and press button 8.

End of programme

At the end of the programme, the washing machine stops automatically, the button 8 light and the Door lock light go off. The

Stand by: once the programme has finished after a few minutes the energy saving system is enabled with the pilot lights switched on. By pressing any button the appliance will come out of the energy saving status.

display shows a flashing zero «0». It is possible to open the door.

If you had selected an option that ends with water left in the tub the Door lock light remains lit to indicate that the water must be drained before opening the door.

To drain or to spin follow the below instructions:

1.Turn the programme selector dial to Off.

2.Select the draining or spinning programme.

3.Reduce the spin speed if needed, by pressing the relevant button.

4.Press button 8.

At the end of the programme, the door can be now opened. Turn the programme selector dial to Off to switch the machine off.

Remove the laundry from the drum. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry.

If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.

15

Image 15
Contents Jlwd Spin washer-dryer General safety Safety informationUse InstallationKeep all detergents in a safe place out of children’s reach Child safetyContents Use Drying Product description Detergent dispenser drawer Control panelTime dry Programme DialSpin Automatic dryStart Pause Door lock light Delay StartDisplay Extra RinseAcoustic signals First usePersonalisation Measure out the detergent Daily useChild lock Load the laundrySelect the desired options Select the delay startSelect the required programme Select the spin speed or Rinse hold optionHow to change an option or a programme during its cycle How to interrupt a programmeStart the programme End of programme How to open the door during the cycle of a programmeDrying only Use DryingUse Washing & Drying NON-STOP programme Washing and Automatic DryingNON-STOP programme Washing and Timed Drying Removing stains Helpful hints and tipsSorting out the laundry Before loading the laundryDetergents and additives Quantity of detergent to be usedDegrees of water hardness Garment labels Drying HintsPreparing the drying cycle Laundry not suitable for dryingWhite and fast coloured cotton heavily or Washing programmesAdditional drying EconomySynthetics Synthetics Easy IronDelicates Drain RinsesDrying Programmes Minute washOff Timed Programmes Automatic ProgrammesDuration Minutes Technical dataConsumption values Programme Energy WaterCare and cleaning Cleaning the drawer recess Washing drumDoor seal Cleaning the pump Cleaning the water inlet filters Emergency emptying out Frost precautionsUnpacking InstallationPlumbing Positioning and levellingWater-stop device Water inletWater drainage Into a drainage standpipeOnto a sink outlet spigot Interest of the environment Special conditionsElectrical connection Permanent connection Appliance is supplied with a 13 amp plug fittedDoes not start Problem Possible cause/SolutionWhat to do if… Washing machineSpin Machine does not fillMachine does not Empty and/or does notMachine vibrates Unsatisfactory washingResults Door will not openRepairs After Sales Service Repairs After Sales Service0844 871 Ecological hints Environment concernsSpare parts Packaging materials132939140-A-022011