•Selection of drying time in minutes. After starting the programme, the remaining time is updated every minute.
If you select a drying time longer than 55 minutes, after a few seconds, the display will show it in hours and minutes.
•Delay start, a time value indicated in hours and selected by the relevant button. The delay time (20 hours max) is displayed for a few seconds, then the
First use
duration of the selected programme reappears. After you have pressed the button 8, the countdown is updated every hour, and, for the last hour, every minute.
•An incorrect option selection has been made: this is indicated by the message Err for a few seconds when an option incompatible with the current programme is selected.
•An alarm code indicates a fault with the machine (see the relevant chapter).
• Ensure that the electrical and water connections comply with the installation instructions.
•Remove the polystyrene block and any material from the drum.
•Before the first wash, run a cotton cycle at the highest temperature without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and start the machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic device, which sounds in the following cases:
•at the end of a washing cycle
•if there is a fault
You can deactivate the acoustic signal (except if there is a fault) by pressing the buttons 5 and the 6 simultaneously for about 5 seconds. By pressing these buttons again the acoustic signal is reactivated.
11