Electrical connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure not be observed.
Should the appliance power supply cableneed to be replaced, this must be carriedout by a Service Force agent (see page 28).
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.
The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used.
Should the plug need to be replaced for any reason, proceed as described below.
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow
Blue
Brown
GREEN & YELLOW
E
| 13 A |
N | L |
|
BROWN
BLUE
|
| CORD CLAMP |
P1041 |
| |
|
|
If you fit your own plug, the colours of the wires in themains lead of your appliance may not correspond with themarkings identifying the terminals in your plug.
Proceed as follows:
1.The wire coloured green and yellow must be connected to the terminal marked with the letter
«E» or by the earth symbol 
or coloured green and yellow.
2.The wire coloured blue must be connected to the terminal marked «N» or coloured black.
3.The wire coloured brown must be connected to the terminal marked «L» or coloured red.
4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
WARNING:
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.
The power supply cable must be easily accessible after installing the appliance.
The appliance should not be connected to the electrical supply by means of anextension cable
Permanent connection
In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
10