John Lewis JLWD 1406 1400 Levelling, Special conditions, Interest of the environment

Page 9

P1212

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

P1197

Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine.

Loop

P1198

Important

Before connecting the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.

Levelling

Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable (check diagonally).

P1051

9

Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation.

Some vibration is inevitable, especially if mounted on a wooden floor.

Sprung wooden floors are particularly susceptible to vibration. For advice, consult a builder. If possible, always place the machine on a solid floor.

Special conditions

If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine.

Warning

The machine should NOT be placed on deep pile carpeting.

Note

Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.

In the interest of the environment

Washing machines and dishwashers should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river.

SHOWER

 

 

 

SINK

TOILET

BATH

 

BIDET

WASHING

DISHWASHER

MACHINE

RAINWATER

 

 

'RUN-OFF'

 

 

 

 

FOUL DRAIN

SURFACE WATER

 

FOUL SEWERS

DRAINS & SEWERS

 

 

 

 

 

SEWAGE

UNTREATED

 

TREATMENT

DISCHARGE

 

WORKS

 

 

TREATED

 

 

DISCHARGE

RIVER

 

RIVER

P0987

 

 

It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution.

If you require any further advice please contact your local water authority.

Image 9
Contents Jlwd Spin washer-dryer Installation Child SafetyUse Service Maintenance and CleaningEcological hints Environmental InformationContents Description of the Appliance Child safety featureDoor locked light Detergent dispenser drawerTechnical Specifications InstallationWashing DryingUnpacking PositioningHoses must bepumped out Water inlet Installation on a Suspended FloorWater drainage Appliance must be connected to a cold water supplySpecial conditions LevellingInterest of the environment Onto a sink outlet spigot«E» or by the earth symbol or coloured green and yellow Electrical connectionPermanent connection Detergent dispenser drawer Programme selector dial Control panelSpin button Option buttonsAutomatic Dry button Delay start buttonTime dry button Start/Pause buttonSelection of drying time in minutes Display Programme timeE20 Programme phase indicator lightsEasy iron Programme informationLoad the laundry Switch the machine onMeasure out the detergent Select the spin speed or the None optionSelect the Delay start How to change an option or a programme during its cycleHow to interrupt a programme Select the desired optionsLeave the door ajar in order to air the machine End of programmeDrying Press the Start/Pause button to start the programme900 r.p.m. for Cottons & Synthetics with electronic drying 1000g = 1 kg SheetBath robe Important Notes Wash Care SymbolsWashing programmes Programme Consumptions Off ResetEnergy Water Time Description KWh SoakDegree Type of fabric Max. load Spin speed Drying time Mins Drying ProgrammesExtra dry Store dryMaintenance and Cleaning Cleaning the water inlet filter Remove any objects from the pump impeller by rotating itScrew the pump cover fully Close the pump door Emergency emptying out Something Not Working Spinning Machine vibrates whenDoor will not open Light has gone out Spinning starts late orAlways insist on genuine spare parts 0870 0105/06 132 981