John Lewis JLTDH15 Electrical connection, Green and Yellow Earth Blue Neutral Brown Live

Page 26

3.Remove foil hose and polystyrene padding from the machine.

Warning! If the appliance was not transported in an upright position, leave it to stand for 12 hours before connecting it to the electricity supply and using it for the first time, so that the oil can flow back to the compressor. Otherwise the compressor could be damaged.

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

Warning! THIS APPLIANCE MUST BE EARTHED. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see chapter: Repairs - after sales service).

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. (See picture on page 6).

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved BS 1363/A fuse must be used. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code:

•Green and Yellow - Earth

•Blue - Neutral

•Brown - Live

GREEN & YELLOW

BROWN

BLUE

CORD CLAMP

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Tumble dryer Important safety information General safetyCause an explosion. Only tumble dry items washed with water InstallationUse Environmental information Child safetyEnvironmental tips Spin the laundry well before dryingPage Contents Adjustable feet Description of the applianceBefore first use Programme selector and Off switchControl panel Time button Display Dry timeProgramme chart Application/propertiesPreparing laundry Sorting and preparing laundrySorting laundry Door opening and laundry loading Switching machine onDaily use Selecting the programmeAnti-crease AlarmIntensive Time Delay startSetting child lock Programme of 20 minutesOpen loading door Changing programmeStarting the programme Drying cycle complete / removing laundry For drying rack unpacking see Installation chapterDrying rack Open doorInstallation and use Drying tipsMaintenance and cleaning Cleaning fluff filterCleaning the door seal Emptying the water reservoirCleaning heat exchanger filters Water reservoir has a volume of approx litresPage When doing this, please use rubber gloves Clean operating screen and housingCleaning the drum What to do ifReplacing the drum light Does not Filters not locked in place Into place CloseAdjusting the level of conductivity Machine settingsAlarm permanent on/off Replace the defective bulb Screw cover back downTransporting the appliance InstallationTechnical information Removing transport safety packaging Appliance positioningElectrical connection Green and Yellow Earth Blue Neutral Brown LiveSymbol or coloured green and yellow Door reversalDrying rack unpacking Mod Repairs after sales serviceSpare parts Page Page 136916260-B-102011
Top Page Image Contents