John Lewis JLTDC11 instruction manual Repairs after sales service, Door reversal, Mod

Page 27

Warning! The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions.

Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre.

Warning! The power supply cable must be accessible after installing the machine.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm

between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Door reversal

To make it easier to load or unload the laundry, the door can be reversed.

Warning! The door must only be reversed by an authorised service engineer.

Please contact your nearest John Lewis branch who will give you details of your local Service Force Centre. The engineer will carry out the door reversal at your cost.

Repairs - after sales service

Your appliance comes with a three year warranty. If it is not working correctly; consult the fault finding guides within this instruction book (Something not working). If a fault occurs which you can not resolve through following the advice and information contained within this instruction manual, the next step is to contact our extended warranty administrators on:

0844 871 7771

They will give you details for your local Service engineer. Before calling out an engineer, please ensure you have read the details under the heading “Something not working”. When you contact your local service engineer you will need to give the following details:

1. Your name, address and post code

2.Your telephone number

3.Clear and concise details of fault

4.The purchase date as found on your receipt

5.The model and serial number of the appliance. So that you always have these numbers at hand, we recommend you to make a note of them here:

Mod.......................................

P.N.C.....................................

S.N.........................................

IMPORTANT : If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made

27

Image 27
Contents Condenser dryer with heat pump General safety Important safety informationUse InstallationChild safety Environmental tipsEnvironmental information Page Contents Description of the appliance Time button Programme selector and Off switchControl panel Before first useProgrammes Programme chartSorting and preparing laundry Sorting laundryPreparing laundry Selecting the programme Switching machine onDaily use Door opening and laundry loadingAnti-crease AlarmRemoved at any time during the anti-crease phase IntensiveDelay start Setting child lockSelect the programme and additional functions Starting the programme Changing programmeDrying cycle complete / removing laundry Maintenance and cleaning Cleaning fluff filterOpen door Clean the entire filter area Emptying the water reservoir Cleaning the door sealCleaning heat exchanger filters Cleaning the drum What to do if Clean operating screen and housingMachine settings Alarm permanent on/offReplacing the drum light Press the Start/Pause button until you set desired level Adjusting the level of conductivityConsumption values Technical specificationsInstallation Transporting the applianceAppliance positioning Electrical connection Removing transport safety packagingGreen & Yellow Brown Blue Cord Clamp Green and Yellow Earth Blue Neutral Brown LiveRepairs after sales service Door reversalMod Spare parts Page Page Page 136909381-00-102009