John Lewis JLTDC11 instruction manual Maintenance and cleaning, Cleaning fluff filter, Open door

The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti- crease phase. (The laundry should be taken out towards the end of the anti- crease phase at the latest to prevent creases from forming.) If Anti-creasefunction has been selected, the anti- crease phase is lengthened by 60 minutes.

1. Open door.

2.Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See “Maintenance and cleaning” chapter.)

3.Remove laundry.

4.Turn the programme selector to Off .

Important! After each drying cycle:

-Clean the micro-fine filter and fine filter

-Drain the condensed water container (See chapter “Maintenance and cleaning ”.)

5.Close the door.

Maintenance and cleaning

Cleaning fluff filter

The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (micro- fine filter and fine strainer) must be cleaned after every drying cycle.

The warning lamp Filter lights to remind you of this operation at the end of each cycle.

Caution! Never operate the dryer without fluff filters or with damaged or blocked fluff filters.

1.Open loading door

2.Use a damp hand to clean the micro- fine filter, which is built into the lower part of the loading aperture.

3.After a period of time, a gleam due to detergent residue on laundry forms on the filters. When this occurs, clean the filters with warm water using a brush.

Remove the filter from the door pulling it out. (It can be positioned with the locating spur facing to the left or to the right).

After cleaning do not forget to put it back.

15