John Lewis JLTDC11 Installation, Transporting the appliance, Appliance positioning

Page 24

Installation

Transporting the appliance

Important! Only tip the appliance on its left side to transport (see illustration), if it cannot be transported in an upright position.

Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine.

To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.

Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is.

The feet must never be removed. Do not restrict the floor clearance through deeppile carpets, strips of wood or similar. This might cause heat built-up which would interfere with the operation of the appliance.

Appliance positioning

It is recommended that, for your convenience, the machine is positioned close to your washing machine.

The tumble dryer must be installed in a clean place, where dirt does not build up.

24

Image 24
Contents Condenser dryer with heat pump Important safety information General safetyInstallation UseChild safety Environmental tipsEnvironmental information Page Contents Description of the appliance Programme selector and Off switch Control panelBefore first use Time buttonProgramme chart ProgrammesSorting and preparing laundry Sorting laundryPreparing laundry Switching machine on Daily useDoor opening and laundry loading Selecting the programmeAlarm Removed at any time during the anti-crease phaseIntensive Anti-creaseDelay start Setting child lockSelect the programme and additional functions Starting the programme Changing programmeDrying cycle complete / removing laundry Maintenance and cleaning Cleaning fluff filterOpen door Clean the entire filter area Cleaning the door seal Emptying the water reservoirCleaning heat exchanger filters Cleaning the drum Clean operating screen and housing What to do ifMachine settings Alarm permanent on/offReplacing the drum light Adjusting the level of conductivity Press the Start/Pause button until you set desired levelTechnical specifications Consumption valuesInstallation Transporting the applianceAppliance positioning Removing transport safety packaging Electrical connectionGreen and Yellow Earth Blue Neutral Brown Live Green & Yellow Brown Blue Cord ClampRepairs after sales service Door reversalMod Spare parts Page Page Page 136909381-00-102009