WAY OF USE & METHOD OF MAINTENANCE
TROUBLE SHOOTING
Weight standard of the clothes
Exceptional
phenomenon
No indication in controller
Cause
The power plug is not plugged tight. The power switch is not switched on.
Not press "START/PAUSE" button.
Solution
Check the power socket, or change other
socket.
Press "START/PAUSE" button.
A suit of work clothes (blended) about 800g
Short sleeves shirt (cotton) about 130g
A pair of pajamas | Long sleeves shirt | Bedsheet (cotton) |
(cotton) about 500g | (blended) about 200g | about 500g |
Bath towel (cotton) | Short pants (cotton) | Socks (blended) |
about 300g | about 50g | about 50g |
The inlet hose
.leakage
Does not drain
Do not rightly connect the tap with the universal connector.
Do not screw tight the nut of the water inlet hose.
The drain hose is wrung or jammed.
Screw tight the nut.
Loosen the drain hose for smooth flow of water
Method Of Maintenance
The following cases are not faults
1.There is water injection in time of washing or rinse, which is due to that the washer senses the inadequacy of water
and exchanges water level automatically.
2.There is the phenomenon of intermittent spinning in the beginning of spinning, which is performed to achieve better
spinning effects.
3.In the course of spin, the program return to the wash program. Because that is designed to rectify the unbalanced distribution of load in the spin tub.
Dose not inject water
Spinning stops and water injecting begains in the course of spin
Stop water.
Do not open the tap.
Whether the wire netting in the water inlet was stopped up by the sundries.
Cause by that the washing placed uneven.
Wait for coming water.
Open the tap.
Clean the netting according to the method of
"Cleaning of the water inlet".
This is automatic rectification for spinning in the washing program. That the washing are too much or too little, or that the washing machine is not placed plane will cause the unbalance in time of spinning. If there is still abnormal circumstances after
After the whole washing program
The washing machine will send off the "DOU- DOU"sound after any program operation to remind you of taking out the load or going on with other operations.
After finishing washing, please shut off the tap, pull out the plug in case of water leakage or fire accident.
Cleaning the water inlet
After long time use, the water inlet mesh bag may be blocked with smudginess, and should be cleaned according to the following steps:
Maintenance of shell
Use soft cloth to wipe off the water and dirt on the surface each time after use of the washing machine. Detergent, propellant and other chemicals are not allowed to use, for they can cause damage to the surface.
Cleaning of the lint filter
After using the washing machine for a period, please clean it according to the following steps:
Does not spin
Intermittent spinning
Before using the machine water exsits
in the drain hose.
After end to drain, do not close the lid. Open the lid in course of spinning.
In order to attain the better spinning
effect.
Remainning water due to testing
or experiment in the factory.
checking the
Close the upper lid.
Belong to the normal phenomenon generally.
Belong to the normal phenomenon generally.
1.Switch on the power, followed by shutting off the tap .
2.Let the washer works for 5 seconds so that water flows into the tub through the water inlet hose. then turn off the power.
3.Unload the water inlet hose and clean the mesh bag, then restore the water inlet assembly.
1.Take out the lint filter.
2.Open the lint filter and wash it clean in the water.
3.Restore it and refix it.
Notices:
The washing machine does not work normally because the voltage is low or too high. Please pull
out the plug and wait till the voltage becomes normal.
If there is still abnormal circumstances after checking the
the plug. Do not repair it by yourself at home, which is very dangerous.
15 | 16 |
|