More about this receiver
Basic operations
Turning off the power
•If you turn off the power while listening to a disc, disc play will start from where playback has been stopped previously, next time you turn on the power.
Tuner operations
Storing stations in memory
•During SSM search...
–All previously stored stations are erased and stations are stored newly.
–Received stations are preset in No. 1 (lowest frequency) to No. 6 (highest frequency).
–When SSM is over, the station stored in No. 1 will be automatically tuned in.
•When storing a station manually, a previously preset station is erased when a new station is stored in the same preset number.
Disc operations
General
•This receiver has been designed to reproduce CDs, and
•When a disc has been loaded, selecting “CD” for the playback source starts disc play.
•Some
–Discs are dirty or scratched.
–Moisture condensation occurs on the lens inside the receiver.
–The pickup lens inside the receiver is dirty.
–
–There are improper recording conditions (missing data, etc.) or media conditions (stain, scratch, warp, etc.).
•
•Do not use the following
–Discs with stickers, labels, or protective seal stuck to the surface.
–Discs on which labels can be directly
printed by an ink jet printer.
Using these discs under high temperatures or high humidities may cause malfunctions or damages to discs.
Changing the source
•If you change the source, playback also stops (without ejecting the disc).
Next time you select “CD” for the playback source, disc play starts from where it has been stopped previously.
ENGLISH
Inserting a disc
•When a disc is inserted upside down, the disc automatically ejects.
•Do not insert 8 cm discs (single CD) and unusual shape discs (heart, flower, etc.) into the loading slot.
Ejecting a disc
•If the ejected disc is not removed within
15 seconds, the disc is automatically inserted again into the loading slot to prevent it from dust. (Disc will not play this time.)
Playing a CD-R or CD-RW
•Use only “finalized”
•This receiver can play back
General settings—PSM
•If you change the “AMP GAIN” setting from “HIGH PWR” to “LOW PWR” while the volume level is set higher than “VOL 30,” the receiver automatically changes the volume level to “VOL 30.”
17