to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.
If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the underside of the base (see Fig. F).
Drill four fixing holes see Fig. G.
| |
| 490 mm |
| 95 mm |
| Front edge |
| 50 mm |
G | Top view |
|
Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow.
The reason for placing the base in this position is to allow a small strip of beading to be fitted in front of the appliance feet.
Fix the base firmly to the floor using four appropriate countersunk screws (see Fig. H).
installation electrolux 39
mmis left between the top of the machine and the underside of the worktop.
A final check for stability should be car- ried out with the machine on spin with a load, this will identify the need for any further fine adjustment to the feet.
A strip of beading approximately 605
mmW, x 5 mm H, x 25 mm D must be screwed down into the base directly in front of the machine’s feet, this will pro- vide additional security.
If required an additional door magnet, part number
Hardwood strip | 5 X 25 X 605 | |
5 mm x 25 mm | ||
490 | ||
|
H
With the appliance installed adjust all four feet ensuring the machine is sta- ble, and a clearance of approximately 5