what to do if... electrolux 27
Malfunction
The machine fills then empties immediately:
Possible cause
●The end of the drain hose is too low.
Solution
●Refer to relevant paragraph in “water drainage” section.
The machine does not empty and/or does not spin:
● The drain hose is | ● Check the drain hose |
squashed or kinked. E20 | connection. |
● The drain pump is | ● Clean the drain pump. |
clogged. E20 |
|
● The Rinse Hold or No | ● Select the Drain or Spin |
Spin option has been | programme. |
selected. |
|
There is water on the floor:
●The laundry is not evenly distributed in the drum.
●Too much detergent or unsuitable detergent (creates too much foam) has been used.
●Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp.
●The drain or inlet hose is damaged.
●The cap on the emergency emptying hose has not been replaced after cleaning the pump.
●Redistribute the laundry.
●Reduce the detergent quantity or use another one.
●Check the water inlet hose connection.
●Replace it with a new one.
●Put the cap back on the emergency emptying hose and place the latter back in its seat.
Unsatisfactory washing results:
●Too little detergent or unsuitable detergent has been used.
●Stubborn stains have not been treated prior to washing.
●The correct temperature was not selected.
●Excessive laundry load.
●Increase the detergent quantity or use another one.
●Use commercial products to treat the stubborn stains.
●Check if you have selected the correct temperature.
●Reduce the laundry load.