Electrolux 12710 VIT, 14710 VIT manual Hinges, Mounting the door, Counter-magnet

Building-in

b) Hinges

To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth

12.5-14 mm) on the inner side of the door. The distance between the holes hobs fixing centres must be 416 mm.

The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions.

35 Ø 12.5-14 depth

16
-
	22

	-598
C	595

B
416 C
	1,5
+
22

The required dimensions are given in the picture C.

The hinges will be fixed to the door by means of screws for wood (2-Fig. B) sup- plied with the appliance.

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x15 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door.

To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

6

4

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the appliance (see picture D).

D

4

5

E

8

6

71

3

8

2

If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the coun- termagnet (6) and the hinges (1) as previously described.

Important: the plastic screw (8) should never be loosened (Fig. B and E).

57