2. Onto a sink outlet spigot.
If the outlet spigot has not been used
before, remove any blanking plug that may be in place.
Push the drain hoseLoop onto the spigot and secure with a clip if required, ensure a
loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Cen- tre. The joining piece must have an internal diameter of 18 mm.
If you intend the drain hose from the machine to empty into a sink, make sure that the sink
is empty and the plug hole is not blocked. Use the plastic “U -Piece” supplied.
Important
Before connecting up the machine to new
pipework or to pipework that has not been used for some time, run off a rea- sonable amount of water to flush out any debris that may have collected in the pipes.
Min. 60
cm
The drain hose may be extend-
ed to a maximum of 4 metres. An additional drain hose and joining piece is available from
your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.
Max. 90
(23.6”)
cm (35.4”)
3 pin
When discharging into a stand- pipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level.
Installation
53