10electrolux
3.press button 8 again to start the pro- gramme.
Important! The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with the draining programme.
START THE PROGRAMME BY PRESSING BUTTON 8
To start the selected programme, press the button 8, the green pilot light of the button 8 stops blinking. The icon 2.8 appears on the display to indicate that the appliance starts operating and the door is locked.
To interrupt a programme which is running, press the button 8: the green pilot light starts to blink.
To restart the programme from the point at which it was interrupted, press the button 8 again. If you have chosen a delayed start, the machine will begin the countdown.
If an incorrect option is selected, the red pi- lot light of the button 8 blinks for 3 times the message Err is displayed for few sec- onds.
SELECT THE TIME MANAGER OPTION BY PRESSING BUTTONS 9
By pressing these buttons repeatedly, the duration of the washing cycle can be in- creased or decreased. The icon 2.12 will appear on the display to indicate the chos- en degree of soil. This option is available only with Cotton, Syntheticand Delicate programmes.
Soil Level |
| Icon |
| Type of fabric |
Super Re- |
| 2) |
| For refreshing a very |
fresh 1) |
|
|
| few items only |
1)We recommend you to reduce the load sizes (see Washing programmes table).
2)When you select this option the relevant icon appears just for a while and then it disappears immediately.
ALTERING AN OPTION OR A RUNNING PROGRAMME
It is possible to change some options be- fore the programme carries them out . Before you make any change, you must PAUSE the appliance by pressing the but- ton 8 (if you wish to change the Time Man- ager option, you must cancel the running programme and make your selection again).
Changing a running programme is possible only by resetting it. Turn the programme se- lector dial to 
and then to the new pro- gramme position. Start the new programme by pressing the button 8 again. The wash- ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro- gramme which is running, the correspond- ing green pilot light starts blinking.
Press the button again to restart the pro- gramme.
CANCELLING A PROGRAMME
Turn the selector dial to 
to cancel a pro- gramme which is running.
You can select now a new programme.
Soil Level
Intensive
Normal
Daily
Light
Quick
Super Quick
1)
Refresh1)
Icon
2)
Type of fabric
For heavy soiled items
For normal soiled items
For daily soiled items
For slightly soiled items
For very slightly soiled items
For items used or worn for a short time
For refreshing items only
OPENING THE DOOR
After the programme has started (or during the delay time) the door is locked, if you need to open it, set first the machine to PAUSE by pressing the button 8.
If the icon 2.8 disappears after some mi- nutes, the door can be opened.
If the icon 2.8 does not go off, this means that the machine is already heating or that the water level is too high. Do not try to force the door!
If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to 
. After a few minutes the door can be opened (pay attention to the water level and temper- ature!).