JVC KD-LH1101 manual Manual preset, Start automatic preset Tune in to a station in this example

ENGLISH

2 Start automatic preset.	2 Tune in to a station (in this example,
1 Press M (MODE).	of 92.5 MHz).
“Mode” appears on the display.	To tune in to stations
The next-step-operation	of higher frequencies
buttons start flashing.

2Press and hold number button 5, while

“Mode” is still on the display. To tune in to stations of lower frequencies

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

“–SSM–” appears, then disappears when automatic preset is over.

Local FM stations with the strongest signals are searched and stored automatically in the band number you have selected (FM1, FM2, or FM3). These stations are preset in the number buttons

—No.1 (lowest frequency) to No.6 (highest frequency).

When automatic preset is over, the station stored in number button 1 will be automatically tuned in.

Manual preset

You can preset up to 6 stations in each band (FM1, FM2, FM3, and AM) manually.

Ex.: Storing FM station of 92.5 MHz into the

preset number 1 of the FM1 band.

1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).

Each time you press the button, the band changes as

follows:

FM1 FM2 FM3 AM

The display pattern automatically changes to the small animation display (see page

14). The preset number flashes for about

5 seconds, then the previous display pattern resumes.

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:

•A previously preset station is erased when a new station is stored in the same preset number.

•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

12