6. Move the machine into position...
INSTALLING YOUR MACHINE
WARNING:
●Do not drag or lift the machine by it’s door.
Your machine is heavy so care must be taken when moving it.
●Please take care not to damage any floor coverings when moving the machine.
●When moving the machine, take care not to kink or damage the hoses at the back of machine.
7. Adjust the feet...
Once the machine is in place
Your machine may become noisy or move about if it is not level. If necessary, to level the machine adjust the two front feet, as follows:
●When your machine is in its intended location, make sure that it is level by turning one or both of the front feet clockwise until the machine stands firm and level.
The maximum slope of the table top must not exceed 2˚.
●The spring on each foot will stop them coming loose.
●Switch the machine on at the plug socket.
Now that you have successfully installed your new machine, we advise that you run it through a 95˚ White Cotton programme without any laundry and without any detergent in it.
This will check your installation, connections and drainage, and will thoroughly clean the interior before you carry out an actual wash programme on your laundry.
NOTE: This will take approximately 2 hours to complete.
Continue reading this book to get to know the various features of the machine.
TECHNICAL DETAILS
|
|
|
|
Models | WD865, WD860 | ||
|
|
|
|
|
| 59.5cm wide | |
Dimensions | 85cm high | ||
|
| 60cm deep | |
|
|
|
|
Capacity | from 1 to 6kg Wash | ||
|
| from 1 to 5kg Dry | |
|
|
|
|
Electric | voltage 220/230 Volts 50Hz | ||
Connections | maximum absorbed power 1700W | ||
|
|
|
|
Spin Speed | up to 1600rpm | ||
|
|
|
|
Control | Cotton wash | ||
programmes | temperature 60˚C | ||
according to | Wash run with a 6kg load | ||
IEC50229 | Dry run with a 1kg load followed | ||
directive | by a 5kg load | ||
|
|
|
|
10