5.Connect the machine to a drainage system...
●Take care when you remove the drain hose from the clips on the back of the machine. All machines are tested with water before they leave the factory so a small amount of water may still be in the hose.
●Do not remove the hooked end support from the GREY drainage hose when using any of the drainage methods detailed below. You may need to reposition it as required along the drainage hose.
●For drainage into a standard work top sink, ensure the outlet pipe has a minimum diameter of 32mm. If your sink is inset, the front edge of the basin must be less than 75mm from the front edge of your worktop, so that the drain hose will hook securely into the sink. Unclip the drainage hose from the back of the machine and hook over into the sink. Make sure that the sink is free of any obstructions and that the sink plug can not fall into the sink, preventing the water from draining away freely. Pumped out water may be very hot.
WARNINGS:
● Take care |
when using |
the sink |
drainage |
system. The |
discharge |
water may be |
very hot. |
● Do not |
position the |
standpipe |
near an |
INSTALLING YOUR MACHINE
figure 1
We recommend one of the following drainage methods:
Standpipe
1 Make sure that the standpipe has a minimum diameter of 38mm.
2Remove the drainage hose from the clips on the back of the machine.
3 Make sure that the top of the
electrical |
socket. |
● Flooding |
could occur |
if any part |
of the |
500 mm standpipe is positioned at least 500mm from the floor (see figure1). Use the plumbing indicator line label on the back of the machine as a guide.
Hooked end support | 4 Place the drainage hose | |
approximately 100mm into the | ||
|
figure 2 |
|
|
| standpipe. |
|
|
| Under sink waste system | |
|
| 1 | Cut out the membrane, bung or | |
|
|
|
| blanking plug (see figure 2). |
| Cut off end | 2 | Unclip the drainage hose from the | |
|
| back of the machine. | ||
|
|
|
| |
|
| 3 | Move the hooked end support along | |
figure 3 |
| |||
|
|
| the drainage hose as required. | |
|
|
|
| |
|
| 4 | Attach the drainage hose securely to | |
|
|
|
| the under sink drainage unit, using a |
|
|
|
| hose clip (see figure 3). |
|
| 5 | Raise the hooked end support up to | |
| Hose clip |
|
| at least 800mm to avoid water being |
|
|
| drawn back into the machine. | |
|
|
|
| |
|
|
|
|
|
If the GREY drainage hose is too short
A longer drainage hose is available from our Genuine Parts & Accessories Mail Order Hotline
UK on 08709 077 077 or www.theservicecentre.co.uk (or in the Republic of Ireland on (01) 842 6836).
installation is |
not carried |
out correctly. |
● Remember |
you will be |
charged for a |
service call |
for problems |
caused by |
incorrect |
installation, |
of transit |
bolts or |
packaging, |
leaks from |
household |
pipework, |
loose or |
blocked fill |
and drain |
hoses. |
9