AEG 12710 manual Positioning, Levelling, Water inlet

Page 47

Installation

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

•Before placing it on small tiles, apply a rubber coating.

•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

•If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances;

•The machine must not be installed in rooms where the temperature can drop below 0.

•The water inlet hose and the drain hose must not be kinked.

•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.

Levelling

Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

Water inlet

Connect the water inlet hose to a separate tap with a 3/4" thread.

The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window “A”. Should this occur, turn the water tap off and refer to your Service Cen- tre to replace the hose.

The other end of the inlet hose which con- nects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.

A

47

Image 47

Contents Lavamat Turbo Electronic Dear customer Contents Page Contents Technical data Service Follow the instructions for positioning and connection Safety instructionsGeneral safety Positioning, connection, starting upProper use Child safetyMachine DisposalTips for environmental protection Packaging materialsMain features of your washer-dryer Front view Description of the applianceProgramme selector dial Control panelSTART/PAUSE button Delay Start buttonProgramme Option buttons Drying Time buttonPrewash Programme progress display DisplayOpening the door after the programme has started Cancelling a programmeAltering a programme which is running Before the first wash Detergent dispenser drawerSorting out and preparing the laundry Preparing the wash cycleCotton 60 Sort of laundry Approximate Dry weightsTypes of fabric and care labels CottonDelicates 40 Detergents and additives Sort of laundry Preparing the drying cycleLoad Garments not suitable for dryingFibre residue Drying symbols on garment labelsDuration of the drying cycle Modification of the drying timeDrying only Max. load How to dryAdditional drying Add detergent and additive How to washLoad the laundry Selection of the spin speed or Rinse Hold option Selection of the desired optionsSelection of the Extra Rinse option Selection of the Delay Start optionAt the end of the programme Starting the programmeNON-STOP programme Automatic washing and dryingWash programmes Programme chartTion Special programmesDescrip Consumption1200 DryingDegree of drying Max. load Spin speed Drying time MinsMax Water Energy Duration Load Litres KWh Minutes Consumption data for dryingDetergent dispenser drawer Cleaning and maintenancePeriodical cleaning Exterior After each washDrain pump Door sealEmergency emptying out Frost precautionsWater inlet filter Something not working? TroubleshootingProblem Possible cause Solution Possible cause Solution ProblemNoisy Feet have not been E10 Problem Possible causeWhite residue is left on the laundry Unsatisfactory washing resultsIf grey stains remain on the laundry Foam is still visible even after the last rinseThis appliance complies with the following EC directives Technical dataService Safety instructions for the installer Instructions for installation and electrical connectionRear view Dimensions of the applianceFront view and side view Unpacking InstallationWater inlet PositioningLevelling Water drainage