AEG 12710 manual Installation, Unpacking

Page 46

Installation

Unpacking

All transit bolts and packing must be removed before using the appli- ance.

Using a spanner,

unscrew and remove the 2 rear

bottom screws. Slide out the 2 plastic pins. Lay

the machine on

its back, taking 025 care not to squash

the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

Remove the polystyrene block from the bottom of the machine and release the two plastic bags.

Carefully slide out the left-hand bag removing it towards the right

and then down- wards.

Slide out the right- hand bag removing it towards the left and then upwards. Set the machine

upright and	P1126
upright and
remove the
remaining rear
screw. Slide out
the relevant pin.
Plug the open
holes with the
plugs which you
will find in the	P1128

plastic bag containing the instruction booklet.

P0001

1 2

3

P1124

P1127

P0002

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

46

Image 46

Contents Lavamat Turbo Electronic Dear customer Contents Page Contents Technical data Service Positioning, connection, starting up Safety instructionsGeneral safety Follow the instructions for positioning and connectionChild safety Proper usePackaging materials DisposalTips for environmental protection MachineMain features of your washer-dryer Description of the appliance Front viewControl panel Programme selector dialDelay Start button START/PAUSE buttonDrying Time button Programme Option buttonsPrewash Display Programme progress displayAltering a programme which is running Cancelling a programmeOpening the door after the programme has started Detergent dispenser drawer Before the first washPreparing the wash cycle Sorting out and preparing the laundryCotton Sort of laundry Approximate Dry weightsTypes of fabric and care labels Cotton 60Delicates 40 Detergents and additives Garments not suitable for drying Preparing the drying cycleLoad Sort of laundryModification of the drying time Drying symbols on garment labelsDuration of the drying cycle Fibre residueAdditional drying How to dryDrying only Max. load Load the laundry How to washAdd detergent and additive Selection of the desired options Selection of the spin speed or Rinse Hold optionSelection of the Delay Start option Selection of the Extra Rinse optionStarting the programme At the end of the programmeAutomatic washing and drying NON-STOP programmeProgramme chart Wash programmesConsumption Special programmesDescrip TionMax. load Spin speed Drying time Mins DryingDegree of drying 1200Consumption data for drying Max Water Energy Duration Load Litres KWh MinutesAfter each wash Cleaning and maintenancePeriodical cleaning Exterior Detergent dispenser drawerDoor seal Drain pumpWater inlet filter Frost precautionsEmergency emptying out Problem Possible cause Solution TroubleshootingSomething not working? Problem Possible cause SolutionNoisy Feet have not been Problem Possible cause E10Foam is still visible even after the last rinse Unsatisfactory washing resultsIf grey stains remain on the laundry White residue is left on the laundryTechnical data This appliance complies with the following EC directivesService Instructions for installation and electrical connection Safety instructions for the installerFront view and side view Dimensions of the applianceRear view Installation UnpackingLevelling PositioningWater inlet Water drainage