Maytag MDG-75 installation manual Preoperational Instructions

Page 36

7.Reversing Models ONLY

Basket (tumbler) dryer should never be operated with less than a 30 lb (14 kg) load (dry weight). The size of the load will affect the coast-down and dwell (stop) times. The basket (tumbler) must come to a complete stop before starting in opposite direction.

a.Microprocessor Models

1)Spin and stop are not adjustable in the Automatic Mode and have been preprogrammed into the microprocessor controller (computer) for 150-seconds spin time in the forward direction, 120-seconds in the reverse direction, and a 5-second dwell (stop) time.

2)Spin and stop times are adjustable in the Manual (timed) Mode.

b.Dual Timer Models

1)Both dwell (stop) and basket (tumbler) spin time are adjustable. (Refer to the illustration on page 41.)

8.Check to insure that ALL setscrews (i.e., basket [tumbler] drive, idler, etc.) are tight.

J.PREOPERATIONAL INSTRUCTIONS

1.To start the dryer:

a.Microprocessor Controller (Computer) Dryers

1)The light emitting diode (L.E.D.) display will read “FILL.”

2)Press the “E” on the keyboard (touch pad).

3)The dryer will start and the display will quickly show “Ld30,” “F180,” the dryer will start, and the L.E.D. display will show “dr30.”

4)To stop the dryer, open the main door and press “CLEAR/STOP” key. Refer to the User’s Manual for detailed operating instructions.

b.Dual Timer Dryers

1)Turn drying timer knob for a time of 20 minutes.

2)Select “High Temp.”

3)Push “Push To Start” Switch.

32

Image 36
Contents MDG-75 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Section Important InformationSafety Precautions What to do if YOU Smell GASPage SPECIFICATIONS/COMPONENT Identification SpecificationsSpecifications Component Identification Page Installation Procedures Location RequirementsUNPACKING/SETTING UP Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Horizontal VentingSingle Dryer Venting Page Page Page Electrical Information Electrical RequirementsMDG-75 Gas Page Single-Phase 1Ø Electrical Connections Leads Page Page GAS Information Type of GAS Page Page Preparation for OPERATION/START-UP Preoperational Tests Basket Coating Preoperational Instructions Shut Down Instructions SERVICE/PARTS Information ServiceParts Warranty Information Returning Warranty CardsRoutine Maintenance CleaningAdjustments LubricationProcedure for Functional Check Replacement Components Page Page Reversing Timer SPIN/DWELL Adjustments Timing LegendData Label Information Data LabelSerial Number Troubleshooting Microprocessor Controller Computer ModelsBlower and fan motors are not operating does not start Failed microprocessor controller computer Failed keyboard touch pad label assembly Microprocessor controller computer L.E.D. display reads Sefl Dryer operates but is taking too long to dry GAS Models AA. Condensation on main door glass Timer Models Blower/fan motors are not operating does not start GAS Models Dryer operates but is taking too long to dry Condensation on main door glass Page Manual Reset HI-LIMIT Instructions P O RTA N T