Maytag MDG-75 installation manual SERVICE/PARTS Information, Service, Parts

Page 38

SECTION IV

SERVICE/PARTS INFORMATION

A. SERVICE

1.Service must be performed by a qualified trained technician, service agency, or gas supplier. If service is required, contact the distributor from whom the MAYTAG equipment was purchased. If the distributor cannot be contacted or is unknown, contact the MAYTAG Customer Service Department for a distributor in your area.

NOTE: When contacting the MAYTAG Customer Service Department, be sure to give them the correct model and serial numbers so that your inquiry is handled in an expeditious manner.

B. PARTS

1.Replacement parts should be purchased from the MAYTAG distributor from whom the MAYTAG equipment was purchased. If the distributor cannot be contacted or is unknown, contact the MAYTAG for a distributor in your area.

NOTE: When ordering replacement parts from the MAYTAG dealer be sure to give them the correct model and serial numbers so that your parts order can be processed in an expeditious manner.

34

Image 38
Contents MDG-75 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Section Important InformationSafety Precautions What to do if YOU Smell GASPage SPECIFICATIONS/COMPONENT Identification SpecificationsSpecifications Component Identification Page Installation Procedures Location RequirementsUNPACKING/SETTING UP Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Horizontal VentingSingle Dryer Venting Page Page Page Electrical Information Electrical RequirementsMDG-75 Gas Page Single-Phase 1Ø Electrical Connections Leads Page Page GAS Information Type of GAS Page Page Preparation for OPERATION/START-UP Preoperational Tests Basket Coating Preoperational Instructions Shut Down Instructions Parts SERVICE/PARTS InformationService Warranty Information Returning Warranty CardsRoutine Maintenance CleaningAdjustments LubricationProcedure for Functional Check Replacement Components Page Page Reversing Timer SPIN/DWELL Adjustments Timing LegendData Label Information Data LabelSerial Number Troubleshooting Microprocessor Controller Computer ModelsBlower and fan motors are not operating does not start Failed microprocessor controller computer Failed keyboard touch pad label assembly Microprocessor controller computer L.E.D. display reads Sefl Dryer operates but is taking too long to dry GAS Models AA. Condensation on main door glass Timer Models Blower/fan motors are not operating does not start GAS Models Dryer operates but is taking too long to dry Condensation on main door glass Page Manual Reset HI-LIMIT Instructions P O RTA N T