Mitsubishi Electronics JT-SB216DS-W-AUS manual Features, Items to check during repair work

Page 4

Items to check during repair work

Inspect the condition of the earth. Correct it if improperly grounded. Also, check to see if a ground fault circuit interrupter is being installed. If not, install one.

Check to see whether or not the air filter and the drain tank are installed securely in place.

Do not leave a towel or other object in the hand-drying area.

Never place any object on the main body nor cover it.

Make sure that the product is not being used in any of the following locations:

Locations where the temperature can exceed 0°C to 40°C. Locations where the humidity can exceed 5%RH to 95%RH. Locations where the unit may come into direct contact with water.

Locations where the unit is under direct or strong sunlight. (May cause sensor to malfunction.) Locations where there is a lot of condensation.

Do not use with chemicals (detergents, etc.) on your hands. (This may reduce the productive life of the unit.) Do not use in locations where corrosive, neutral, or reductive gases are present.

(This may reduce the productive life of the unit and/or cause malfunctions.) Locations where solt damage may occur.

Places lower than -20m or higher than 2000m above sea level.

Upon completing repair work, verify that the product operates normally. Clean the product's main body and sur- rounding area, and notify the customer of the completion of the repair work.

1. Features

1Speed drying

Equipped with a turbo fan, the hand dryer blows away drops of water on the hands with a high-speed jet air from a large air volume, high-speed rotary DC brush-less blower, thus quickly draying the hands.

2Easy to use

The rubbing of the hands is no longer necessary. With the hand dryer, you can dry both hands by just insert- ing and then removing them slowly.

3Hygienic

The hand dryer is automatically started by a sensor. Thus, there is no need to touch the hand dryer with your wet hands. It is very hygienic.

4Antibacterial

The hand dryer uses a silver inorganic substance; thus, maintaining an antibacterial effect for an extended period of time.

The hand dryer meets the antibacterial effect standard defined by the Society of Industrial Technology for Antimicrobial Articles (SIAA).

5Easy maintenance

The hand dryer does not require a paper or cloth towel, thus eliminating the dumping of paper waste and the exchanging of towels. Also, the hand dryer is easy to clean.

6Highly safe with mischievous use prevention timer

To prevent continuous operations of the hand dryer by mischievous use or malfunction, it has a built-in timer that automatically stops drying upon reaching a specific period of time.

7Economical

The monthly electricity expense is the only expense the hand dryer requires. Thus, it is extremely economi- cal for use over an extended period of time.

—4—

Image 4
Contents Hand Dryer Contents Safety precautions Turn off the powerFeatures Items to check during repair workNames and functions of the hand dryers components Specifications DimensionsWiring diagrams Troubleshooting LED1 LED2Resistance at two places between each pair Resistance values between black and white, red Replace the bottom light emitting boards and the light Reference data LED display list Description How to call Overhaul procedure Turning power offPower switch Technical notesDisplay board Control board Blower Light emitting board topLight emitting board bottom Light receiving board Precautions when replacing Product Sequence timing chart Description of circuit operation Hand detection and hand dryer operation Control of the blower motorCircuit diagram and items to check Board diagram and items to check Parts list JT-SB216DS-W-AUS Page Drain tank Page Blower cover 1962 Pcs/unit For safety 9819 35 MEE