Mitsubishi Electronics JT-SB216DS-W-AUS manual Precautions when replacing Product

Page 20

5Remove the panel (rear).

*Be careful not to drop the water immersion protective rubber (indicated by ).

*Replace the packing of the disassembled part with a new one.

*When replacing the packing, be careful not to twist it.

6Remove the light receiving board holder clamping screws (two PTT screws 4 x 16, indicated by ).

*Replace the packing of the disassembled part with a new one.

*When replacing the packing, be careful not to twist it.

7Remove the light receiving board from the holder. Remove the two claws (indicated by ).

*Replace the packing of the disassembled part with a new one. *When replacing the packing, be careful not to twist it.

*Precautions when replacing Product

Cautions:

Reverse the order to replace the Product.

Make sure that the proper functioning of the unit is restored when the repair is complete.

—20—

Image 20
Contents Hand Dryer Contents Safety precautions Turn off the powerFeatures Items to check during repair workNames and functions of the hand dryers components Specifications DimensionsWiring diagrams Troubleshooting LED1 LED2Resistance at two places between each pair Resistance values between black and white, red Replace the bottom light emitting boards and the light Reference data LED display list Description How to call Overhaul procedure Turning power offPower switch Technical notesDisplay board Control board Blower Light emitting board topLight emitting board bottom Light receiving board Precautions when replacing Product Sequence timing chart Description of circuit operation Hand detection and hand dryer operation Control of the blower motorCircuit diagram and items to check Board diagram and items to check Parts list JT-SB216DS-W-AUS Page Drain tank Page Blower cover 1962 Pcs/unit For safety 9819 35 MEE