Mitsubishi Electronics JT-SB216DS-W-AUS manual Light receiving board

Page 19

ARemove the board fixing plate clamping screws (two PTT screws 4 x 16, indicated by ●).

BRemove the light emitting board (bottom) from the board fixing plate, and disconnect the lead wires.

(8) Light receiving board

1Perform the same work as in steps 1 through B of (7) above.

2Reverse the main body, remove the clamping screws (twelve special black screws 4 x 16, indicated by ●) from the rear surface, and then reverse the main body back to the original position again.

3Remove the panel (center).

4Remove the duct (T-shaped) clamping screws (three PTT screws 4 x 16, indicated by ●).

—19—

Image 19

Contents Hand Dryer Contents Turn off the power Safety precautionsItems to check during repair work FeaturesNames and functions of the hand dryers components Dimensions SpecificationsWiring diagrams LED1 LED2 TroubleshootingResistance at two places between each pair Resistance values between black and white, red Replace the bottom light emitting boards and the light Reference data LED display list Description How to call Technical notes Overhaul procedureTurning power off Power switchDisplay board Control board Light emitting board top BlowerLight emitting board bottom Light receiving board Precautions when replacing Product Sequence timing chart Description of circuit operation Control of the blower motor Hand detection and hand dryer operationCircuit diagram and items to check Board diagram and items to check Parts list JT-SB216DS-W-AUS Page Drain tank Page Blower cover 1962 Pcs/unit For safety 9819 35 MEE