3.6. Starting the programme
After you chose the washing programme, press the Start/Pause pushbutton to start the cycle. The corresponding light stays on. It is normal that the programme selector does not turn during the cycle.
When the washing cycle begins, the «washing» light is on.
3.7. Action during a programme
3.7.1. Adding of laundry
Press the Start/Pause pushbutton : the corresponding light flashes as long as the programme is paused. You will then hear a double "click" in the locking device when the cover opens. Press the same pushbutton again to resume the programme.
For reasons of safety, you cannot open the cover if the temperature of the washing water is too high.
3.7.2. Modifying the current programme
Before modifying the current programme, you must put the washing machine to pause by pressing on the «Start/Pause» pushbutton. If it is impossible to make the modification, the corresponding light flashes for few seconds. If you decide to change the programme in any case, you will need to cancel the current programme (see below).
3.7.3. Cancelling the programme
If you want to cancel a programme, turn the programme selector knob to the «off» position of the programme selector.
You can then select a new programme after cancelling the previous one.
3.8. End of program
The washing machine stops automatically. You will hear a double "click" in the locking device when the cover opens. The cycle end light goes on.
If you choose the rinse hold position on the spin speed variator, the rinse hold light* illuminates to inform you that water has to be drained before you can open the cover. To terminate the cycle, you can then spin the washing by choosing the spin program or drain it by choosing the drain program.
Turn the program selector knob to the "Off" position. Take out the laundry.
*depending to the model
Pull out the power supply plug and close the water sup- ply tap.
Note: we recommend that you should leave the cover and the drum open after use to air the washing drum.
6