Bradley Smoker EXD-2N installation instructions Installing bowl

Page 7

 

Express® Deck Lavatory System EXD-Series

Installation Instructions

EXD-2N

 

 

Installation Instructions continued . . .

Step 3: Installing bowl

WARNING: To prevent serious injury and/or damage to the bowl, move and position the bowl with the assistance of another person and always use appropriate lifting procedures.

NOTE: Refer to Figure 4 below when installing the bowl.

1.With someone to assist you, place the bowl squarely onto the frame.

2.Attach the front underside of the bowl to the frame using the two 1/4"-20 x 1/2" pan-head screws and washers provided. Do not tighten bolts at this time.

IMPORTANT: When bolting the bowl to the frame and wall, do not overtighten bolts. Overtightening bolts can damage the Terreon® material.

3.After the bowl is attached to the frame, use 3/8" bolts and 1" min. O.D. washers (supplied by the installer) to bolt the bowl to the wall anchors, two places.

4.Tighten the screws installed in procedure #2 above to secure the bowl to the frame. Do not overtighten.

Figure 4

BOWL

1/4-20 SCREWS AND WASHERS

(2)PLACES BOWL/FRAME MOUNTING

MAIN FRAME

3/8" BOLT AND WASHER

SCUFF BASE FRAME

AND DRAIN ASSEMBLY

(2) PLACES FOR

NOT SHOWN FOR CLARITY

BOWL MOUNTING

 

Bradley Corporation • 215-1542 Rev. E; EN 06-915

2/9/07

7

Image 7
Contents Express Deck Lavatory System EXD-Series Installation InstructionsEXD-2N Standard Height Supplies required for installation Installation InstructionsRough Option #2 EXD-2N Express Deck Lavatory System DimensionsMounting frame to wall Procedure #3 on page 4 FigureInstalling bowl Connecting supply and drain Optional hot water heater Completing installationPanel cleaning Cleaning and Maintenance InstructionsTerreon and panel maintenance CleaningPrepack Assembly of ComponentsProblem Limited water flow Thermostatic Mixing Valve Maintenance and TroubleshootingProblem External leaks in the system Repair Kit S65-259 Vernatherm Thermostatic Mixing Valve S01-524