GE Monogram DCXH46, PSXH43, DSXH43, DPXH46, DH43 GAS Connection for GAS Dryers

Page 18

Installation Instructions

GAS CONNECTION FOR

GAS DRYERS

1.Remove the shipping cap from gas pipe at the rear of the dryer.

Conversion to LP Gas: DO NOT connect the dryer to LP gas service without converting the gas valve. An LP conversion kit (Pub. No. 14–A038)MUST be installed by a qualified gas technician.

a. Connect a 1/2″ (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to

the 3/8″ (0.96 cm) pipe located on the back of the dryer. Use a 1/2″ to 3/8″ (1.27 cm to 0.96 cm) reducer for a connection. Apply an approved thread sealer that is resistant to the corrosive action of liquefied gases on all pipe connections.

b. Open the shutoff valve in the gas supply line.

c. Test all connections by brushing on a soapy water solution.

WARNING: NEVER TEST FOR GAS LEAKS WITH AN OPEN FLAME.

2.Connect the exhaust duct to outside exhaust system. Use duct tape to seal all joints.

3.With the dryer in its final position, adjust one or more of the legs until the dryer is resting solidly on all four legs. Place a level on top of the dryer. THE DRYER

MUST BE LEVEL AND RESTING SOLIDLY ON ALL FOUR LEGS.

4.Plug the power cord into a grounded outlet. NOTE: Check to ensure the power is off at circuit breaker/fuse box before plugging the power cord into the outlet.

5.Turn on the power at the circuit breaker/fuse box.

CAUTION: Before operating the dryer, make sure the dryer area is clear and free from combustible materials, gasoline, and other flammable vapors. Also see that nothing (such as boxes, clothing, etc.) obstructs the flow of combustion and ventilation air.

6.Run the dryer through a cycle check for proper operation.

NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time the dryer is turned on, the safety switch will shut the burner off. If this happens, turn the timer to OFF and wait 5 minutes before making another attempt to light.

7.If your dryer does not operate, please review the Troubleshooting Tips section in this manual before calling for service.

8.Place these instructions in a location near the dryer for future reference.

18

Image 18
Contents 175D1807P460 350A4502P325 Rev 134287400GE & You, a Service Partnership Two easy ways to register your applianceVicinity of this or any other appliance Gas supplier Do not store or use gasoline or otherFlammable vapors and liquids Clear the room, building or area of all occupantsYour Laundry Area When not Using Your Dryer Fabric Care Features and appearance may varyAbout the dryer control panel Drying CyclesReplacing the Dryer Light Bulb on some models About your dryer featuresWrinkle Care Option on some models Drying Rack on some modelsLoading and using the dryer Sorting and Loading HintsCompletion time 1-3 hours Commonwealth of MassachusettsRead these instructions completely and carefully Exhausting sectionInstallation Instructions Read these instructions completely and carefully Electrical Connection Information for Electric DryersExhaust System Requirements Correct IncorrectFollowing directions must be followed Exhaust Ducting Length Exhaust DirectionGAS Supply Requirements Location of Your Dryer Do not install the dryer on carpetAllow the following clearances for ease of installation Custom-sized countertop is requiredMobile Home Installation ROUGH-IN Dimensions See the Exhaust System Requirements section for otherDryer is designed under Ansi Z For a grounded, cord-connected electric dryer Electrical Installation for Electric DryersGrounding Requirements For a permanently connected electric dryerWire System for Electric Dryers Canada a 4-wire power supply cord is installed on the dryerGAS Connection for GAS Dryers Must be Level and Resting Solidly on ALL Four LegsTools Required for Stacking the Dryer Mounting the Dryer to the WasherNumbers in the illustration correspond to steps Stacking Instructions-Reversing Door Swing Reversing the Dryer Door SwingBefore you call for service… To dry Static occursClothes take too long Clothes are wrinkledSafety Instructions Models DSXH43 and DH43 Model DPXH46GE Will Replace What GE Will Not CoverModel DCXH46 Model PSXH43Consumer Support Canada, callCanada geappliances.ca, or write to