GE Monogram DCXH46, PSXH43, DSXH43, DPXH46, DH43 Tools Required for Stacking the Dryer

Page 19

Stacking Instructions

WARNING:

•To reduce the risk of electric shock, disconnect this appliance from the power supply before attempting any user maintenance. Turning the controls to the OFF position does not disconnect this appliance from the power supply.

•Refer to the washer and dryer installation instructions prior to stacking appliances. Reading all of the information contained in these instructions will simplify the installation and ensure a correct and safe operation. A fire hazard and/or personal injury could result from improper installation.

TOOLS REQUIRED FOR STACKING THE DRYER

•Phillips head screwdriver

•Channel-lock adjustable pliers

MOUNTING THE DRYER TO THE WASHER

The numbers in the illustration correspond to steps.

1.Remove the washer top panel by first removing the 4 screws in the 2 brackets located on the top rear of the washer.

Slide the top forward, lift the front of the top up and remove the top panel.

Remove the 2 brackets from the rear of the top panel.

2.Using the 4 screws that were removed in step 1, install the brackets in the rear support as shown.

3.Remove the 4 screws and the 2 long front brackets located on the top front of the washer.

4.Install the 2 new front mounting brackets provided and the 4 screws that were removed in step 3. Note that the tab of the front mounting bracket is facing forward as shown in the illustration.

19

Image 19

Contents 350A4502P325 Rev 134287400 175D1807P460Two easy ways to register your appliance GE & You, a Service PartnershipClear the room, building or area of all occupants Do not store or use gasoline or otherFlammable vapors and liquids Vicinity of this or any other appliance Gas supplierYour Laundry Area When not Using Your Dryer Drying Cycles Features and appearance may varyAbout the dryer control panel Fabric CareDrying Rack on some models About your dryer featuresWrinkle Care Option on some models Replacing the Dryer Light Bulb on some modelsSorting and Loading Hints Loading and using the dryerExhausting section Commonwealth of MassachusettsRead these instructions completely and carefully Completion time 1-3 hoursInstallation Instructions Electrical Connection Information for Electric Dryers Read these instructions completely and carefullyCorrect Incorrect Exhaust System RequirementsFollowing directions must be followed Exhaust Direction Exhaust Ducting LengthGAS Supply Requirements Custom-sized countertop is required Do not install the dryer on carpetAllow the following clearances for ease of installation Location of Your DryerSee the Exhaust System Requirements section for other Mobile Home Installation ROUGH-IN DimensionsDryer is designed under Ansi Z For a permanently connected electric dryer Electrical Installation for Electric DryersGrounding Requirements For a grounded, cord-connected electric dryerCanada a 4-wire power supply cord is installed on the dryer Wire System for Electric DryersMust be Level and Resting Solidly on ALL Four Legs GAS Connection for GAS DryersMounting the Dryer to the Washer Tools Required for Stacking the DryerNumbers in the illustration correspond to steps Reversing the Dryer Door Swing Stacking Instructions-Reversing Door SwingBefore you call for service… Clothes are wrinkled Static occursClothes take too long To drySafety Instructions What GE Will Not Cover Model DPXH46GE Will Replace Models DSXH43 and DH43Model PSXH43 Model DCXH46Canada, call Consumer SupportCanada geappliances.ca, or write to