GE Monogram PSXH43 Stacking Instructions-Reversing Door Swing, Reversing the Dryer Door Swing

Page 20

Stacking Instructions–Reversing Door Swing

The numbers in the illustration correspond to steps.

5.Using the blade end of a putty knife covered with masking tape, carefully remove the hole plugs located in the bottom of the dryer front panel.

6.Remove the 4 legs from the dryer base.

7.Place the dryer on top of the washer. Slide the dryer back into the rear brackets (7A) then drop the front down over the front brackets (7B).

8.Insert the 2 long screws provided in the kit through the holes in the dryer front panel and install into the front mounting brackets.

9.Install the hole plugs removed in step 5.

10.Refer to the washer and dryer installation instructions for proper installation and function.

11.Save the top panel and brackets in the case of future side-by-side use.

REVERSING THE DRYER

DOOR SWING

1.Open the dryer door. Remove the 4 hinge hole plugs or screws from the left side of door opening. Place nearby for future installation. NOTE: You may need a plastic knife to help pull out the plugs. Be careful not to scratch the paint.

2.Remove the four screws that secure the door hinges to the dryer front panel. NOTE: Remove 1 screw from each of the 2 hinges first. Hold the door firmly before removing the last 2 screws.

3.Rotate the door 180° and reinstall the door hinges to the dryer front panel with the 4 screws.

4.Install the 4 hinge hole plugs or screws that were removed in step 1 into the open screw holes on the right side of the door opening.

20

Remove 4 screws—one from each hinge first

Image 20

Contents 175D1807P460 350A4502P325 Rev 134287400GE & You, a Service Partnership Two easy ways to register your applianceDo not store or use gasoline or other Flammable vapors and liquidsVicinity of this or any other appliance Gas supplier Clear the room, building or area of all occupantsYour Laundry Area When not Using Your Dryer Features and appearance may vary About the dryer control panelFabric Care Drying CyclesAbout your dryer features Wrinkle Care Option on some modelsReplacing the Dryer Light Bulb on some models Drying Rack on some modelsLoading and using the dryer Sorting and Loading HintsCommonwealth of Massachusetts Read these instructions completely and carefullyCompletion time 1-3 hours Exhausting sectionInstallation Instructions Read these instructions completely and carefully Electrical Connection Information for Electric DryersFollowing directions must be followed Exhaust System RequirementsCorrect Incorrect GAS Supply Requirements Exhaust Ducting LengthExhaust Direction Do not install the dryer on carpet Allow the following clearances for ease of installationLocation of Your Dryer Custom-sized countertop is requiredDryer is designed under Ansi Z Mobile Home Installation ROUGH-IN DimensionsSee the Exhaust System Requirements section for other Electrical Installation for Electric Dryers Grounding RequirementsFor a grounded, cord-connected electric dryer For a permanently connected electric dryerWire System for Electric Dryers Canada a 4-wire power supply cord is installed on the dryerGAS Connection for GAS Dryers Must be Level and Resting Solidly on ALL Four LegsNumbers in the illustration correspond to steps Tools Required for Stacking the DryerMounting the Dryer to the Washer Stacking Instructions-Reversing Door Swing Reversing the Dryer Door SwingBefore you call for service… Static occurs Clothes take too longTo dry Clothes are wrinkledSafety Instructions Model DPXH46 GE Will ReplaceModels DSXH43 and DH43 What GE Will Not CoverModel DCXH46 Model PSXH43Canada geappliances.ca, or write to Consumer SupportCanada, call