GE Monogram DCXH46, PSXH43, DSXH43, DPXH46, DH43 Commonwealth of Massachusetts

Page 9

Installation Instructions

Spacemaker Dryer

Models DCXH46

DSXH43

DPXH46

DH43

PSXH43

If you have any questions, in the U.S., call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com

In Canada, call 1.800.361.3400 or visit our Website at: geappliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•IMPORTANT – Save these

instructions for local inspector’s use.

•IMPORTANT – Observe all

governing codes and ordinances.

•Note to Installer – Be sure to leave these instructions with the Consumer.

•Note to Consumer – Keep these instructions for future reference.

•Skill level – Installation of this appliance requires basic mechanical and electrical skills.

•Completion time – 1–3 hours

•Proper installation is the responsibility of the installer.

•Product failure due to improper installation is not covered under the Warranty.

IN THE COMMONWEALTH OF MASSACHUSETTS

•This product must be installed by a licensed plumber or gas fitter.

•When using ball-type gas shut-off valves, they shall be the T-handle type.

•A flexible gas connector, when used, must not exceed 3 feet.

FOR YOUR SAFETY:

WARNING

•This dryer must be exhausted to the outdoors. Use only rigid metal or flexible metal 4" diameter ductwork for exhausting to the outside. Use only rigid metal 4" diameter ductwork inside the dryer cabinet.

•Never use plastic or other combustible ductwork. See

Exhausting section.

•This appliance must be properly grounded and installed as described in these Installation Instructions.

•Do not install or store appliance in an area where it will be exposed to water/weather. See Location of Your Dryer section.

•The National Fuel Gas code restricts installations of gas appliances in garages. They must be 18″ (45.7 cm) off the ground and protected from vehicles by a barrier. See Location of Your Dryer section.

•The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70 or in Canada, CSA C22.1 Canadian Electrical Code Part 1.

•The gas service to the dryer must conform with local codes and ordinances or the latest edition of the National Fuel Gas Code ANSI Z223.1 or in Canada, CAN/CGA B149.12. The gas dryer is designed under ANSI Z 21.5.1 or ANSI/UL2158–CAN/CSA C22.2 (latest editions) for home use only. This dryer is not recommended for commercial applications such as restaurants or beauty salons.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 350A4502P325 Rev 134287400 175D1807P460Two easy ways to register your appliance GE & You, a Service PartnershipFlammable vapors and liquids Do not store or use gasoline or otherVicinity of this or any other appliance Gas supplier Clear the room, building or area of all occupantsYour Laundry Area When not Using Your Dryer About the dryer control panel Features and appearance may varyFabric Care Drying CyclesWrinkle Care Option on some models About your dryer featuresReplacing the Dryer Light Bulb on some models Drying Rack on some modelsSorting and Loading Hints Loading and using the dryerRead these instructions completely and carefully Commonwealth of MassachusettsCompletion time 1-3 hours Exhausting sectionInstallation Instructions Electrical Connection Information for Electric Dryers Read these instructions completely and carefullyExhaust System Requirements Correct IncorrectFollowing directions must be followed Exhaust Ducting Length Exhaust DirectionGAS Supply Requirements Allow the following clearances for ease of installation Do not install the dryer on carpetLocation of Your Dryer Custom-sized countertop is requiredMobile Home Installation ROUGH-IN Dimensions See the Exhaust System Requirements section for otherDryer is designed under Ansi Z Grounding Requirements Electrical Installation for Electric DryersFor a grounded, cord-connected electric dryer For a permanently connected electric dryerCanada a 4-wire power supply cord is installed on the dryer Wire System for Electric DryersMust be Level and Resting Solidly on ALL Four Legs GAS Connection for GAS DryersTools Required for Stacking the Dryer Mounting the Dryer to the WasherNumbers in the illustration correspond to steps Reversing the Dryer Door Swing Stacking Instructions-Reversing Door SwingBefore you call for service… Clothes take too long Static occursTo dry Clothes are wrinkledSafety Instructions GE Will Replace Model DPXH46Models DSXH43 and DH43 What GE Will Not CoverModel PSXH43 Model DCXH46Consumer Support Canada, callCanada geappliances.ca, or write to
Top Page Image Contents