About your dryer features.
Safety
CYCLE SIGNAL
OFF | LOUD |
Cycle Signal Option (on some models)
When the signal is on it will sound just before the end of the cycle to remind you to remove the clothes. The signal can be set at OFF (no sound), LOUD or anywhere in between.
If the dried load cannot be removed promptly during the EASY CARE cycle, the Cycle Selector will advance to the EXTENDED COOL DOWN setting. Unheated tumbling continues during EXTENDED COOL DOWN and WRINKLE CARE (on some models) for 40 minutes to help reduce wrinkling. When the CYCLE SIGNAL is on, it will sound briefly every
five minutes as a reminder to remove the load.
NOTE:
■If items are removed before the end of the cycle, turn the CYCLE SELECTOR knob to OFF.
■Remove garments promptly at the sound of the signal. Place clothes on hangers so wrinkles won’t set in.
■Use the Cycle Signal especially when drying fabrics like polyester knits and permanent press. These fabrics should be removed so wrinkles won’t set in.
Instructions Operating
WRINKLE CARE
EXTENDED COOL AIR TUMBLE
ONOFF
Wrinkle Care Option (on some models)
Use this option to minimize the wrinkles in clothes. It provides approximately 15 minutes of
This option can only be used with the EASY CARE and DELICATES cycles.
Instructions Installation
Replacing the Dryer Light Bulb (on some models)
Light cover
Pry with flat blade
screwdriverLight housing
WARNING: To reduce the risk of electric shock, disconnect this appliance from the power supply before attempting any user maintenance. Turning the controls to the OFF position does not disconnect this appliance from the power supply.
The dryer light is located above the dryer door opening.
Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution
panel by removing the fuse or switching off the circuit breaker.
To replace the dryer light:
1 | Using a small flat blade screwdriver, | |
pry the bottom of the light cover out | ||
| ||
| and off the light housing. | |
| Unscrew the bulb when cool and | |
2 | ||
replace it with an appliance bulb of | ||
| ||
| the same or lower wattage. | |
| Snap the light cover back on the light | |
3 | ||
housing. | ||
|
Drying Rack (on some models)
A handy drying rack may be used for drying articles such as stuffed toys, pillows or washable sweaters.
1 Remove the lint screen.
2 Place the front bar under the lip of the lint screen opening.
3 When items are dry, remove the rack and replace the lint screen. DO NOT
OPERATE THE DRYER WITHOUT THE LINT SCREEN IN PLACE UNLESS THE DRYING RACK IS IN PLACE.
NOTE:
■The drying rack must be used with the
TIMED DRY cycle.
■Do not use this drying rack when there are other clothes in the dryer.
7
Instructions Troubleshooting Tips
Customer Service