INSTALLATION INSTRUCTIONS
VENTING THE DRYER (continued)
Routing and Connecting Ductwork
Follow the guidelines below to maximize dryer performance and reduce lint buildup and condensation in the ductwork.
NOTE: Transition duct (from dryer to wall) and fittings are NOT included and must be purchased separately.
•Use 4 inch (102mm) diameter rigid or
•The exhaust duct run should be as short as possible.
•Use as few elbow joints as possible.
•The male end of each section of exhaust duct must point away from the dryer. See figure on lower right of page.
•Use duct tape on all joints. Never use screws.
•Insulate ducts that runs through unheated areas in order to reduce condensation and lint buildup on duct surfaces.
•The total length of
WARNING: Failure to follow these guidelines will result in poor performance, product failure, and/or result in fire or death.
IMPORTANT: Failure to exhaust the dryer, per the guidelines included within these instructions, may result in unsatisfactory dryer performance. All venting and ductwork beyond the exterior of the dryer is the responsibility of the consumer. Product failure, as a result of improper venting, is not covered by the dryer warranty.
Correct Venting |
Incorrect Venting |
Connecting the Dryer Vent
1Verify all ducts and elbows are clean and free from any blockages.
2Measure duct length. DO NOT exceed the maximum length listed in the Duct Length Chart.
3Connect dryer exhaust to existing duct.
•Only use duct tape or clamps.
•DO NOT use screws to secure ductwork.
•Use rigid or
•DO NOT use plastic or thin metal foil tubing for ductwork.
•The male end of each elbow must always point in the direction of the airflow.
Male
Ends
15