Electrolux TK K2 E user manual What to do if, Troubleshooting by yourself

what to do if ... electrolux 25

What to do if ...

Troubleshooting by yourself

If, during operation, the dryer shows an error (one or more leds flashing on the control panel), check first of all whether you can remedy the problem yourself by means of the table below. If you cannot solve the problem: Switch the machine off and on again. Reset programme. Press the Start/Pause button. If the error is still shown, please contact our after-sales service and inform them which leds are flash- ing.

Problem

Dryer does not work.

Drying results unsatisfactory.

Possible cause

Mains plug is not plugged in or fuse is not working correctly.

Loading door is open.

Have you pressed the Start/ Pause button?

Wrong programme selec- ted.

Lint filters clogged.

Fluff filter clogged.

Heat exchanger clogged with lint.

Overloading of laundry.

Ventilation slots in base area covered up.

Residue on inside surface of drum or drum ribs.

Conductance of water at in- stallation site differs from standard setting of machine.

Remedy

Plug in at mains socket. Check fuse in fuse box (domestic installation).

Close loading door.

Press the Start/Pause but- ton again.

Select a different pro- gramme the next time you dry (see “Programme chart” chapter).

Clean lint filters.

Clean fluff filter.

Clean heat exchanger.

Observe recommended loading volumes.

Uncover ventilation slots in base area.

Clean inside surface of drum and drum ribs.

Re-programme standard setting for degree of drying (see ‘Machine settings’ chapter).