Changing bulb for interior light

Problem	Possible cause	Remedy
Drying cycle ends	Not enough washing load-	Select time programme or
shortly after pro-	Not enough washing load-	higher drying level (e.g. INTEN-
shortly after pro-	ed or washing loaded is too	higher drying level (e.g. INTEN-
gramme starts. END	ed or washing loaded is too	SIVE DRY instead of STORAGE
gramme starts. END	dry for selected programme.	SIVE DRY instead of STORAGE
display illuminated.		DRY).
	Lint filter clogged.	Clean lint filter.
Drying cycle lasts an	Heat exchanger clogged	Clean heat exchanger.
unusually long time.	with lint.	Clean heat exchanger.
unusually long time.	with lint.
Note:	SPECIAL CARE button	SPECIAL CARE is only suitable
After around 5 hours	SPECIAL CARE button	SPECIAL CARE is only suitable
After around 5 hours	pressed and load volume too	for use with loads of up to
the drying cycle ends	pressed and load volume too	for use with loads of up to
the drying cycle ends	big.	3kg!
automatically (see	big.	3kg!
automatically (see
„Drying cycle com-	Load volume too big.	Reduce load volume.
plete“).		Laundry must be adequately
	Laundry insufficiently spun.	Laundry must be adequately
	Laundry insufficiently spun.	spun.
		spun.

Only use a special bulb which is designed specially for dryers. The spe- cial bulb is available from the local Service Force Centre.

1 Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!

1 Warning! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully remove the fuse.

1.Unscrew the lampcover (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Replace the lampcover.

1Warning! For reasons associated with safety, the lampcover must be screwed down tightly. If this is not done, the dryer must not be operat- ed.