Electrolux LAVATHERM 57810 manual Permanent Connection

Page 27

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely.

Permanent Connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

This appliance complies with the requirements laid out in the EEC Di- rective 76/899.

Voltage 240 V AC: Fuse rating 13amps See rating plate for further information. This appliance meets VDE requirements.

Particular regulations of local electricity authorities must be observed. This appliance conforms to EEC Directive No. 82/499/EWG on radio in- terference.

1 WARNING! Repairs to electrical appliances must only be carried out by trained personnel. Improper repairs may lead to serious risks for the us- er.

27

Image 27
Contents Lavatherm Dear Customer Following symbols are used in the textContents Installation and connection instructions Safety Prior to initial start upIntended use Packaging material Child safetyGeneral safety DisposalEnvironmental tips Old appliancePre-draining Drying cycle Operating screen Description of machinePreparing laundry Before the first drying cycleSorting and preparing laundry Sorting laundryFunctions Programme Application/properties Care SymbolsOverview of programmes Additional30 MIN 1kg Application/properties Care SymbolsSelecting the programme Switching machine on / switching light onDrying Opening loading door / filling laundryIntensity Selecting additional functionsSetting time delay Starting the programmeChanging programme Drying cycle complete / removing laundry Removing laundry or loading laundry when necessaryCleaning lint filter Cleaning and maintenanceClean the entire filter area Cleaning the door sealEmpty water reservoir after every drying cycle Emptying the water reservoirCleaning heat exchanger Problem Possible cause Remedy Cleaning the drumClean operating screen and housing Troubleshooting by yourselfProgramme Time Changing bulb for interior light Objective Implementation Programming optionsEnergy Technical dataConsumption values ProgrammeRemoving transport safety packaging Installation safety instructionsElectrical connection Permanent Connection Door reversal instructions Special accessories Intermediate installation kits for stacked washer and dryerInstallation kit for external condensate drain Great Britain Warranty conditionsFor Customer Service in the Republic 0870 5 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG