Electrolux 59840 user manual Machine settings, Buzzer permanent off

Machine settings 31

Machine settings

Setting				Implementation
BUZZER permanent off	1.	Turn the programme selector to any programme.
	2.	Press simultaneously the DRYNESS and SPIN SPEED
		buttons and hold down for approx. 5 seconds.
	3.	The buzzer is by default always off. You can use BUZ-
		ZER button to activate or deactivate sound but ma-
		chine does not memorize your selection.
Water hardness	1.	Turn the programme selector to any programme.
Water contains, a variable quantity of	2.	Press simultaneously the DRYNESS and TIME buttons
		and hold down for approx. 5 seconds. The current
limestone and mineral salts of which
		setting is on the display:
quantities vary according to geographi-
		–		low conductivity <300 micro S/cm
cal locations thus varying its
conductivity values.		–		medium conductivity 300-600 micro S/
Relevant variations of the conductivity			cm
of the water compared to those prefixed		–		high conductivity >600 micro S/cm
by the factory could slightly influence	3.	Press the START PAUSE button sequentially until you
the residual humidity of the laundry at
		set desired level.
the end of the cycle. Your dryer allows
	4.	To memorize setting press simultaneously the DRY-
you to regulate the sensitivity of the
		NESS and TIME buttons or turn knob to OFF position
drying sensor based on conductivity
values of the water.
Emptying water tank - warning mes-	1. Turn the programme selector to any programme.
sage permanent off	2. Press simultaneously the SPIN SPEED and TIME but-
When using an external drain for the		tons and hold down for approx. 5 seconds.
		The current setting is on the display:
condensed water.
		–	warning	icon and	- warning message
			is off
		–	warning	icon and	- warning message
			is switched on
	By default the warning message is switched on and dis-
	played always at the end of the drying cycle or during
	the cycle if the water container is full.