Electrolux 59840 user manual Permanent connection, Changing door stop

Page 37

Installation 37

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

Changing door stop

WARNING!

The door stop may only be changed by a specialist. If necessary, please contact our after-sales service or your specialist dealer.

WARNING!

Before changing the door stop, disconnect the mains plug.

1.Open loading door.

2.Unscrew hinge A from the front of the machine and take off the loading door.

3.Remove cover plates B and C. To do this, insert a thin screwdriver into the slots as shown in the illustration, press down- wards slightly and pry out the cover plates.

4.Use an appropriate tool and exert pres- sure to unfasten locking block D from the snap-on fixture, take out and re-in- sert on the other side having rotated the block through 180°.

5.Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down.

A	C
B	D
A	C

6.Re-insert cover plates B and C on the opposite site having first rotated them through 180°.

Image 37

Contents Lavatherm Dear Customer Contents European Guarantee Guarantee/Customer ServiceGeneral safety Important safety informationInstallation Use Child safetyProduct description Control panel What is shown in the displayBefore first use Sorting laundry Sorting and preparing laundrySorting by care label. The care labels mean Preparing laundryTime Programme chartMixed BED Linen Viscose Jeans Wool Daily use Switching machine on / switching light onOpening loading door / loading laundry Selecting the programmeSetting the pre-drainage spin speed Setting dryness levelPress the Dryness button repeatedly until If the washing in the washing machine wasBuzzer Setting long anti-crease functionTime Setting child lock Setting delay timerChanging programme Starting the programmePress the Start Pause button. The pro- gramme is started Open door Drying cycle complete / removing laundryClose the door Cleaning fluff filter Care and cleaningAfter cleaning do not forget to put it back Clean the entire filter area Emptying the condensate tank Cleaning the door sealEmpty condensate tank after every drying cycle Cleaning heat exchanger filter Care and cleaning Open loading door Cleaning the drum Clean operating screen and housing What to do if Troubleshooting by yourselfWhat to do if Changing the bulb for interior lightingWhat to do if Replace defective bulb Screw cover back down Buzzer permanent off Machine settingsUse Domestic Permissible ambient temperature + 5C to + 35C Technical dataHints for test institutes Consumption valuesCotton cycle with nominal and half load Transporting the appliance InstallationAppliance positioning Remove foil hose and polystyrene padding from the machine Removing transport safety packagingElectrical connection Changing door stop Permanent connectionIntermediate installation kit for stacked washer and dryer Special accessoriesInstallation Packaging material EnvironmentOld appliance Environmental tips Standard guarantee conditions Guarantee/Customer ServiceService and Spare Parts ExclusionsCustomer Care 01 4090751 Email service.eid@electrolux.ieEuropean Guarantee Service Deutschland +49 Schweiz Suisse Svizzera 125989520-01-14012008