bühler
Allied
Loader
Possible Attachment Interference (2895E TSL & 2895E S TSL)
Regular loader linkage setup allows for maximum rollback.
TSL loader linkage setup provides reduced rollback.
When fully rolled back, large attachments (such as the C2000 Grapple) may contact the 2895E TSL or the 2895E S TSL pivot plate. This interference is avoided in factory assembly by installing the linkages (item 12) in the limited rollback position. These linkages can be reversed to increase attachment rollback if large attachments are not used. See following description below to reverse links.
Before reversing the linkages, remove attachments and engage the hydraulic loader lock (refer to page 23 for hydraulic loader lock instructions).
Refer to pages 36 and 37 for corresponding item and part numbers.
Remove the 1.25 x 7.25 pin (item 40) connecting the linkages (items 11 & 12).
Remove the 1.25 x 6.25 pin (item 17) connecting the linkages (item 12) to the quick attach (item 2).
Reverse the all four linkages (item 12), and reinstall pins and quick attach.
Note: For maximum rollback, the flat side of the linkages (item 12) with one notch should be facing forward. For limited rollback, the arced side of the linkages with two notches should be facing forward.
- 40 - | P4493 |